User's Manual

Mainboard User's Manual Page 23
BIOS Setup
Boot Other Devices
Specifies whether BIOS to boot from other device not listed in the
1st/2nd/3rd Boot Device options when BIOS fail to boot from those
devices. Default setting is "YES".
Swap Floppy Drive
Set this option to "Enabled" to permit drives A: and B: to be swapped.
Default is "Disabled".
Boot Up Floppy Seek
Specify whether floppy drive A: will perform a Seek operation at system boot.
Default setting is "Disabled".
Boot Up NumLock Status
Set this option to "OFF" to turn the Num Lock key off when the computer
is booted so you can use the arrow keys on both the numeric keypad and
the keyboard. Default is "ON".
Gate A20 Option
Sets "Fast", lets chipset control Gate A20; Sets "Normal", lets a pin in the
keyboard controller control Gate A20. Default setting is "Fast".
Typematic Rate setting
Enabled / Disabled Typematic Rate setting, when enabled,the typematic rate
and typematic delay can be selected. Default setting is "Disabled".
Security Option
Enables password checking every time the computer is powered on or every
time BIOS Setup is executed. If System is chosen, a user password prompt
appears every time the computer is turned on. If "Setup" is chosen, the
password prompt appears if BIOS Setup is executed. Default is "Setup".
OS Select For Dram > 64MB
Set to "Enabled" if running OS/2 operating system and using more than
64MB system memory. Default is "Disabled".