Technical data

C B

EFORE OPERATION

1. Inserting batteries in remote control

Placing the batteries

Remove the battery cover in the direction of the arrow.

Place the new batteries as indicated (ensure that the positive (+) and negative

oles (-) are in the correct positions. Slide the battery cover back into place.

Storage of the remote control and tips for use

The remote control can be placed in the wall-mounted holder. De wall-mounted holder is delivered toge-

ther with the unit.

Using the remote control

Point the remote control at the receiver on the indoor unit of the air conditioner. The air conditioner can

be operated in this manner up to a distance of approximately 7 meters.

2. Attaching filters

This air conditioner is equipped with a 3 layer filter package to clean the circulated room air:

• Screen filter: captures large dust particles.

• Enzyme filter: neutralizes airborne micro organisms.

• Active carbon filter: removes unpleasant odours from the air.

a. Open the front panel by pulling upward

b. Remove the screen filters carefully. Push up the center tab of each screen filter

slightly until it is released from the stopper, and remove the filters.

c. Attach active carbon and enzyme filter in the filterholder on each side of the

air conditioner.

d. Attach the screen filters behind the stopper so that the “FRONT” indication is

showing outward. Make sure that the filters are completely behind the stop-

pers. If the filters are not attached correctly, it may cause defects.

e. Close the front panel by pushing downward.

Air filters

Screen

filters

Enzyme

filter

Active carbon filter

NOTE

Use 2 AAA (1.5 Volt) batteries. Do not use rechargeable batteries. Replace the batteries with new

batteries of the same type (see above) when the display starts to fade.