Technical data

Test operation
• Same switch as used in Emergency operation.
• Test operation is needed in special occasion when you need to test
the “cooling operation” even with the room temperature below
16°C, therefore it is not for the normal operation at all.
• Press the Emergency operation switch and hear the beep once, then
keep on pressing the switch for more than 5 seconds but no more
than 10 seconds. After the first 5 seconds you will hear two beeps
then release the switch and you will have the Test Operation Mode.
• The Test Operation Mode will run the air conditioner at “cooling”
with air flow speed at “Hi” for 30 minutes and stops automatically.
Termination of emergency or test operation
• You can terminate the operation when you hear a beep by either pressing the switch once more, or by
operating through remote control.
• When you operate through remote control, is automatically get back to just normal operation mode by
remote control.
E AIR FILTER
This air conditioner is equipped with a Mold proof dust filter, to clean the circulated room air.
The Mold-Proof filter (screen filter) has to be cleaned regularly with a vacuum cleaner to avoid blocking of
the air flow. Or take out the filter and wash with water. After washing, dry the filter completely in the
shade.
G
NOTE
To run the unit without Mold-Proof filter does not bring any harm to the airconditioner. In that
case dust is not removed from the circulated air.
G
NOTE
Emergency operation at the temperature between above 23°C and below 26°C just switch the
machine in operation in “cooling mode” without actually “cooling”. It is not possible to operate
in “Dry” mode.
Temperature
Operation
m
ode
Designated
t
emperature
Timer mode Air flow
A
bove 23°C
C
ooling
2
6°C
C
ontinuous
A
utomatic
Below 23°C Heating 23°C Continuous Automatic
4
16
man_S15xx.qxd 07-02-2007 16:55 Pagina 16