man_S15xx.
man_S15xx.qxd 07-02-2007 16:54 Pagina 2 Dear Sir, Madam, Congratulations on the purchase of your Zibro airconditioner. You have acquired a high quality product that, if used responsibly, will give you many years of pleasure. Please read these instructions for use first in order to ensure the maximum life span of your airconditioner. On behalf of the manufacturer, we provide a 24-month guarantee on all material and production defects. Please enjoy your airconditioner.
man_S15xx.
man_S15xx.qxd A 07-02-2007 16:54 Pagina 4 SAFETY INSTRUCTIONS Install the device only when it complies with local regulations, by-laws and standards. The unit is only sui- G table for use in dry locations, indoors. Check the mains voltage and frequency. This unit is only suitable for earthed sockets, connection voltage 220 - 240 V. / 50 Hz. IMPORTANT • The device MUST always have an earthed connection. If the power supply is not earthed, you may not connect the unit.
man_S15xx.qxd 07-02-2007 16:54 Pagina 5 Do not install in the following places: • Heat or steam is generated in the vicinity. • Under influence by the atmosphere containing in excess salt (in coastal area), sulphide gas (in spa), ammonia, steam of high temperature and vapor. • Air flow from outlet is blocked, for example by snow. • Where oil is dispersed or oil fumes hang over. G B ATTENTION! • Never use the device with a damaged power cord, plug, cabinet or control panel.
man_S15xx.qxd 07-02-2007 16:54 Pagina 6 Air Inlet grill Mold-proof Air Filters * two on each side Remote Signal Receiver Horizontal louver*** Vertical louver*** Air outlet *** The air flow direction can be adjusted with the vertical and horizontal louvers. - Beeping sound assures successfull signal transmission between wireless remote and the indoor unit. Operating panel / POWER Operating panel The test operation switch is used as an emergency operation switch. 1.
man_S15xx.qxd 07-02-2007 16:55 Pagina 7 Remote Control 1 1 TRANSMITTER 9 2 11 3 12 4 13 5 14 6 15 7 Sends signals to the receiver of the indoor unit. 2 FAN SPEED INDICATION Indicates the fan speed selected by the fan speed button. When set at “AUTO”, the fan speed changes automatically according to the difference between the designated temperature and the room temperature.
man_S15xx.qxd C 07-02-2007 16:55 Pagina 8 BEFORE OPERATION 1. Operating the Remote Controller Install / Replace Batteries Use two dry alkaline batteries (AAA/LR03). Do not use rechargeable batteries. 1. Remove the battery cover on the back of the Remote Control by pulling it according to the arrow direction shown on the cover. 2. G Insert new batteries making sure that the (+) and (-) of battery are installed correctly. 3. Reattach the cover by sliding it back into position.
man_S15xx.qxd 07-02-2007 16:55 Pagina 9 How to attach the air clean filters a. Open the front panel by pulling upward G b. Remove the outer air filters. Push up the center tab of each filter slightly until it is released from the stopper, and remove the filter downward. Air filters c. CAUTION Do not touch the metalic parts to avoid injury, when attaching filters. Attach the air filters. Attach the air filters behind the stopper so that the “FRONT” indication is showing outward.
man_S15xx.qxd 07-02-2007 16:55 Pagina 10 Circulating Operation What is Circulating Operation? When you use other heating equipment, warmed air accumulates in the upper space of the room. When the room temperature reaches the temperature set by the remote controller, the indoor unit starts air circulating operation automatically to equalize temperature differences between the upper and lower spaces of the room and consequently improves the heating efficiency. 1. Press the ON/OFF button. 2.
man_S15xx.qxd 07-02-2007 G 16:55 Pagina 11 NOTE! • Even if you press the ON button right after the operation stop, the air conditioner will not start operation for approx. 3 min. in order to protect the compressor. The operation will start automatically after 3 min. of waiting. • If the unit operates cooling and dry for a long time in high humidity (i.e., windows and doors are opened), dew and water droplets may form on the indoor unit.
man_S15xx.qxd 07-02-2007 16:55 Pagina 12 Automatic operation In automatic operation the air conditioner selects the operation mode (cooling, dry, heating) according to the room temperature when it starts. • The air conditioner will restart in the previous mode if autoHow to select operating mode Heating Dry matic operation is resumed within 3 hours from the switch- Cooling Room temperature off.
man_S15xx.qxd 07-02-2007 16:55 Pagina 13 Air flow adjustment Vertical adjustment During Cooling, Dry During Circulating, Operation Dry Operation Approx. 10 degrees ON/OFF button is pressed. level Swing of air flow level Approx. 60 degrees (70) The vertical louver will keep moving within the range illustrated on the level Approx. 10 degrees Approx. 45 level degrees Approx. 10 degrees (40) Approx.
man_S15xx.qxd 07-02-2007 16:55 Pagina 14 Programming the “ON Time” 1. Press the “TIME ADJ” 2 times. 2. Adjust the time with the button. The time setting changes in 10-minu- te intervals. Hold the button to fast forward the time. 3. Press the “TIME ADJ” button two times. The setting of “ON Time” is complete and the present time appears. 4. Press the “ON/OFF” button. Proceed from Step 5 (below) if the unit has been operated or the OFF Timer has been set. 5. Press the timer fixing button “ON”.
man_S15xx.qxd 07-02-2007 4. 16:55 Pagina 15 Press the “ON/OFF” button. Proceed from Step 5 (below) if the unit has been operated or the ON Timer has been set. 5. Press the timer fixing button “ON”. The “ON Time” is displayed for 2 seconds and then the present time appears. Cancelling “OFF Timer” Press the timer fixing button “OFF”. The timer lamp of the indoor unit goes off. “SLEEP Timer” Pressing this button starts the timer mode that will stop the operation after the setting time.
man_S15xx.qxd 07-02-2007 16:55 Pagina 16 Temperature Operation mode Designated temperature Timer mode Air flow Above 23°C Cooling 26°C Continuous Automatic Heating 23°C Continuous Automatic G Below 23°C NOTE Emergency operation at the temperature between above 23°C and below 26°C just switch the machine in operation in “cooling mode” without actually “cooling”. It is not possible to operate in “Dry” mode. Test operation • Same switch as used in Emergency operation.
man_S15xx.qxd F 07-02-2007 G 16:55 Pagina 17 MAINTENANCE WARNING! Before maintenance, be sure to turn off the system and the circuit breaker. Remote controller Do not use water, wipe the controller with a dry cloth. Do not use glass cleaner or chemical cloth. Indoor body Wipe the air conditioner by using a soft and dry cloth. For serious stains, use a neutral detergent diluted with water. Wring the water out of the cloth before wiping, then wipe off the detergent completely.
man_S15xx.qxd G 07-02-2007 G 16:55 Pagina 18 TROUBLE SHOOTING CAUTION! In the event of a malfunction (burning smell, etc.) immediately stop operation, disconnect the Power Supply plug and consult sales shop. Before requesting service, perform the following checks: Problem Cause / Solution The system does not start re-operation immediately. This is for protection of the system. After a stop, the sys-tem does not start operation for approx. 3 min Smells are generated.
man_S15xx.qxd H 07-02-2007 16:55 Pagina 19 GUARANTEE CONDITIONS The air conditioner is supplied with a 24-month guarantee, commencing on the date of purchase. All material and manufacturing defects will be repaired or replaced free of charge within this period. The following rules apply: 1. We expressly refuse all further damage claims, including claims for collateral damage. 2. Repairs to or replacement of components within the guarantee period will not result in an extension of the guarantee. 3.
man_S15xx.qxd I 07-02-2007 16:55 Pagina 20 TECHNICAL DATA Model Type air-conditioner S 1523 S 1526 S 1534 S 1550 S 1564 Wall mounted split Wall mounted split Wall mounted split Wall mounted split Wall mounted split Cooling capacity (max) * W 2300 2600 3400 5000 6400 Cooling capacity (max) * btu/h 7850 8870 11600 17060 21840 B A A C C W/W 3.1 3.22 3.21 2.81 2.
07-02-2007 16:55 Pagina 42 DISTRIBUTED IN EUROPE BY PVG INTERNATIONAL B.V. q SCHWEIZ PVG Schweiz AG Salinenstrasse 63 4133 PRATTELN tel: +41 61 337 26 51 fax: +41 61 337 26 78 email: pvgint@zibro.com 2 DEUTSCHLAND PVG Deutschland GmbH Siemensstrasse 31 47533 KLEVE tel: 0800 - 9427646 fax: +31 (0)412 648 385 email: pvgdeutschland@zibro.com 6 DANMARK Appliance A/S Blovstroed Teglvaerksvej 3 DK-3450 ALLEROED tel: +45 70 205 701 fax: +45 70 208 701 email: appliance@appliance-group.com 5 ESPAÑA PVG España S.
