Specifications

E EMPTYING THE WATER RESERVOIR

In extreme circumstances it may be necessary to empty the internal water

reservoir. When the water reservoir is full, the transparent

- ring around the

button on the front of the device  flashes RED. To empty the water reservoir,

take the following action:

Do not move the device. This may cause water leakage.

First switch the device off and remove the plug from the socket.

Place a pan or container on the floor under the water drain .

Remove the rubber plug from the water drain  and let the water drain out

(± 1 litre).

Insert the rubber plug back into the water drain , push the plug into the

socket and switch the device on. The warning signal should now be off.

F CONNECTION TO A PERMANENT DRAIN

First switch the device off and pull the plug out of the socket.

Place a pan or container on the ground under the water drain  in order to

catch any remnant water.

Remove the rubber plug from the water drain .

Slide a water drain hose over the water drain .

NOTES!

• Never use the airconditioner without the mesh filter!

• Using the device without the activated carbon filter and/or 3M

HAF

filter will not damage the device. In this case, particles that may be

detrimental to health are not removed.

• Filter packages are available at your dealer.

• Only use suitable Zibro filters. This will prevent any damage to your

airconditioner. Using other than the original filters is entirely at the

risk of the consumer. This may have a negative effect on the

operation of the device and may result in damage. The device may

also leak water subsequent to the formation of ice.

NOTE!

Under normal conditions, the condensed water in the airconditioner is

removed via the air outlet hose.

man_Px2xx_1.qxd:man_P122-125.qxd5 22-12-10 15:56 Page 65