Specifications

4
61
STERIONIZER
TM
FUNCTION
Press Sterionizer
TM
function to start the function and press again to stop it.
Positive and
negative ions are generated in every operating mode.
LOW NOISE BUTTON
During unit operation. Press low noise button , unit operates at low noise.
Press the button again to cancel the low noise setting and return to the previous
setting. In low noise mode the unit will provide less cooling or heating capacity.
COOLING
When the cooling mode is activated, the transparent
1
/
2
- ring around the button
on the front of the device  emits a BLUE light.
The following settings are possible in the cooling mode:
• The ventilator speed can be adjusted by pressing the -button
Automatic regulation of ventilator speed
High
Average
Low
• The temperature can be set between 16°C and 32°C (PH227 + PH233: 16°C -
27°C) by pressing the  and  buttons. The display on the remote control
shows the set temperature.
DEHUMIDIFICATION
When the dehumidification mode is activated, the transparent
1
/
2
- ring around the
button on the front of the device  turns YELLOW.
The dehumidification function can be used in different ways.
1) All models:
Only connect the air exhaust hose  to the air outlet  and lead it outside, as
when using the device in the cooling function with a single hose. Place the hose in
such a way that the hot air is expelled outside. The device will then dehumidify
the air in the room and remove excess moisture through the air hose.
2) All models:
Do not connect the air supply nor the air exhaust hose. Remove the rubber plug
from the water drain  and ensure that the water can run out safely (e.g.
through a drain hole in the floor). You can also connect a water hose to the water
drain (see chapter F).
3) PH227 + PH233:
Connect the supplied water hose  to the plug that fits into the water drain.
Lead the other end to a drain or sink and insert the plug into the water drain .
Do not connect both the air supply  and the air exhaust hose. The condensed
G
Whether the desired temperature can actually be reached depends on
the ambient conditions. The room temperature remaining above the set
temperature is normal.
Dehumidifying mode (yellow)
PH227 +
PH233
Cooling mode (blue)
man_Px2xx_1.qxd:man_P122-125.qxd5 22-12-10 15:56 Page 61