Specifications

PLACING BATTERIES IN THE REMOTE CONTROL

Remove the battery cover by pressing the lips in and then pulling the cover

toward you. Place the new batteries as indicated (pay attention to the plus- (+)

and minus poles (-). Now replace the battery cover.

Push the plug into the socket.

By pressing both  and  set buttons at the same time, the display will

toggle between Celsius and Fahrenheit.

The following functions can be selected with the mode button on the

remote control.

Automatic regulation of ventilator speed

Cooling;

Dehumidifying;

Circulating;

Heating (PH227 + PH233).

AUTOMATIC

In the automatic mode , the device will automatically cool, dehumidify or heat

depending on the ambient temperature. When the temperature in the room

changes, the mode changes automatically in order to maintain the by factory set

temperature as accurately as possible. The ventilator speed also adjusts

automatically. The colour of the transparent

- ring around the button on the

front of the device  will change depending on the mode.

Factory settings automatic mode

For models without heat function

When the room temperature is 25ºC or above, the appliance will start the cooling

mode. When the room temperature below 25ºC, the appliance will start the

dehumidifying mode. In this function the air will get cooler.

For models with heat function

When the room temperature is 25ºC or above, the appliance will start the cooling

mode. When the room temperature is between 18ºC and 24 ºC, the appliance will

start the dehumidifying mode. In this function the air will get cooler. When the

room temperature is below 18ºC, the appliance will start the heating mode.

Each mode is determined by the temperature only, not the humidity.

NOTE!

Use 2 AAA (1.5 Volt) batteries. Do not use rechargeable batteries.

Replace batteries with new batteries of the same type when the display

becomes fuzzy or the signal deteriorates.

man_Px2xx_1.qxd:man_P122-125.qxd5 22-12-10 15:56 Page 60