Technical data

4
129
K T
ROUBLE SHOOTING TIPS
M
alfunctions and Solutions
Problem Cause Solution
Unit does not start Power cut Wait for power to be restored.
Unit may have become unplugged. Check that plug is securely in wall
receptacle.
Fuse may have blown. Replace fuse / reset relay / reset
circuitbraker
Battery in Remote controller may have
been exhausted.
Replace the battery.
Distance remote controller to receiver
on the indoor unit is more than 6 to
7 meters, or there are obstacles in
between the remote controller and the
receiver.
Shorten the distance. Remove possible
obstacles. Aim the remote controller
towards the receiver on the indoor unit.
The time you have set with timer is
incorrect.
Wait or cancel timer setting.
Unit not cooling or
heating room very well
while air fl owing out
from the air conditioner
Inappropriate temperature setting. Set temperature correctly. For detailed
method please refer to "operation with
remote control" chapter E.
Air fi lter is blocked. Clean the air fi lter.
Doors or windows in room are open. Close the doors or windows.
Air inlet or outlet of indoor or outdoor
unit has been blocked.
Clear obstructions away fi rst, then
restart the unit.
Compressor 3 minutes delay protection
has been activated.
Wait.
Defrosting of outdoor unit being
performed.
Fan speed cannot be
changed
Airconditioner is in automode Fan speed can only be changed in HEAT,
COOL and FAN mode
Airconditioner is in dry mode
TEMP. Indicator is not
shown
Airconditioner is in fan mode Temperature cannot be set in FAN
mode
G
TROUBLE
Stop the air conditioner immediately if one of the following faults occur. Disconnect the power
and contact your supplier.
Fuse blows frequently or circuit breaker trips frequently.
Other objects or water penetrate the air conditioner.
The remote controller won't work or works abnormally.
Other abnormal situations.
Operation indicator flashes 5 times every second, even after mains electricity has been
disconnected and reconnected.
man_S13xx_SC13xx.qxd:man_S18xx 24-11-10 12:33 Page 129