Specifications

4
65
E EMPTYING THE WATER RESERVOIR
In extreme circumstances it may be necessary to empty the internal water
reservoir. When the water reservoir is full, the transparent
1
/
2
- ring around the
button on the front of the device B flashes RED. To empty the water reservoir,
take the following action:
Do not move the device. This may cause water leakage.
First switch the device of
f and remove the plug from the socket.
Place a pan or container on the floor under the water drain 8.
Remove the rubber plug from the water drain 8 and let the water drain out
(±
1 litre).
Insert the rubber plug back into the water drain 8, push the plug into the
socket and switch the device on. The warning signal should now be of
f.
F CONNECTION TO A PERMANENT DRAIN
First switch the device off and pull the plug out of the socket.
Place a pan or container on the ground under the water drain 8 in order to
catch any remnant water
.
Remove the rubber plug from the water drain 8.
Slide a water drain hose over the water drain 8.
Lead the other end of the water drain hose to suitable place (drain/sink).
Ensure that the drain hose is not twisted or kinked.
G
ATTENTION!
The hose must be descending along its entire length.
5
4
3
2
1
G
NOTE!
Under normal conditions, the condensed water in the airconditioner is
removed via the air outlet hose.
5
4
3
2
1
man_Px2xx_1.qxd 19-05-2008 11:53 Pagina 65