Specifications

4
31
J MALFUNCTION, CAUSES AND SOLUTIONS
C
heck the following before requesting technical assistance:
Dehumidifier
Heating
The manufactur
er reserves the right to alter this information without prior notice.
M
ALFUNCTION
The machine does
not operate.
the machine does
not reduce
humidity.
The dehumdifier
operates, but does
not r
educe
humidity.
C
AUSES
The plug is not in the
socket.
The control button is at
the lowest setting.
The reservoir is full.
The reservoir has not been
installed properly.
The air filter is dirty.
The temperature or
humidity in the room
where the dehumidifier
has been placed is too low.
The room is too big.
Ther
e are too many
sources of humidity.
S
OLUTIONS
Put the plug in the socket.
Turn the control button to
the desired setting.
Drain the water from the
reservoir.
Install the reservoir correctly.
Clean the air filter.
It is normal that the de-
humidifier does not reduce
humidity under exceptional
conditions (see Technical
specifications).
We recommend that you
place more dehumidifiers.
W
e recommend that you
place more dehumidifiers.
MALFUNCTION
The heater does
not work.
The machine does
not generate heat.
CAUSES
The plug is disconnected
from the wall socket.
The ventilator/selector
switch is switched of
f.
The thermostat is at the
lowest setting.
The ventilator/selector
switch is either switched
off or to the ventilator
setting.
The thermostat is at the
lowest setting.
The over
heating safety
system is working because
the air
flow is blocked.
SOLUTIONS
Insert the plug into the wall
socket.
Turn the regulator button to
the desir
ed position.
Adjust the thermostat (see
heating instructions for use).
Turn the selector to the hot
or extremely hot air setting
(see heating instructions for
use).
Adjust the thermostat to the
desir
ed temperature.
Switch the machine of
f,
disconnect it and remove the
blocking object. Let the
machine cool down for 15
minutes. Before
reconnecting it, make sure
that the space around and
above the machine is free (so
the airflow is not blocked).