Specifications

Getting Started
INSTALLING THE ZT 8832 WITH STD ROM
The fastest way to begin using the ZT 8832 is with the addition of
development software from Ziatech. The STD ROM development
system connects the ZT 8832 to an IBM-compatible personal
computer through a serial link. The personal computer is used as a
development station to create, download, and debug applications
written in assembly, C, and other high level languages.
If the ZT 8832 and STD ROM are ordered together, Ziatech
configures the ZT 8832 and tests the system level operation. If the
ZT 8832 and STD ROM are ordered separately, or the system has
been altered and no longer functions properly, refer to Figure 2-1 and
check the following configuration requirements.
Memory Requir
ements
The STD ROM firmware is shipped in a 64 Kbyte EPROM. Install
the EPROM into the ZT 8832 socket labeled ROM. The 28-pin device
must be right-justified in the 32-pin socket, as shown in Figure 2-1.
STD ROM requires 2 Kbytes of RAM memory, from address 0
through 7FFh. Installing a 32 Kbyte RAM in the socket labeled RAM
LOW meets this requirement. The 28-pin device must be right-
justified in the 32-pin socket, as shown in Figure 2-1. If more than
32 Kbytes is needed, a second 32 Kbyte device can be added to the
RAM HIGH socket, or larger RAM devices can be used.
Cable Requir
ements
STD ROM requires a serial link between the ZT 8832 and the
terminal or PC. The ZT 90069 cable shipped with the STD ROM
system is used for this purpose. Plug the cable into the J5 connector of
the ZT 8832 as shown in Figure 2-1.
2-5