Specifications

Specifications
J1: J1 is a nonlatching 26-pin (dual 13-pin) male transition
connector with 0.1 inch lead spacing. J1 provides 24 digital
I/O lines, fused +5 V ±10%, and ground. Table B-3 on
page B-11 lists the pin assignments. These pin assignments
enable the ZT 90068 cable to connect J1 directly to an I/O
module mounting rack with 8, 16, or 24 positions. For
applications not using this cable, the mating connector is a
T&B Ansley #622-2630 or equivalent.
J2: J2 is a latching 14-pin (dual 7-pin) male transition connector
with 0.1 inch lead spacing. The 82050 serial port is available
as RS-232-C or RS-422/485 through connector J2. The pin
assignments for RS-232-C are given in Table B-4 on
page B-12, and the pin assignments for RS-422/485 are given
in Table B-5 on page B-13. The mating connector is a T&B
Ansley #622-1430 or equivalent.
J3: J3 is a latching 10-pin (dual 5-pin) male transition connector
with 0.1 inch lead spacing. The V40 counter/timer and
interrupt inputs are available through connector J3. Table B-6
on page B-14 lists the pin assignments. The mating connector
is a T&B Ansley #622-1030 or equivalent.
J4: J4 is a 36-pin (dual 18-pin) female SBX connector with
0.1 inch lead spacing. This connector includes the power,
address, data, and control signals needed to add custom I/O to
the ZT 8832. Table B-7 on page B-15 lists the pin
assignments. The mating connector is a Viking 000292-00003
or equivalent.
J5: J5 is a 3-pin male low profile header with 0.1 inch lead
spacing. The V40 serial port is available through this
connector. Table B-8 on page B-16 lists the pin assignments.
The mating connector is a Molex 39-01-0033 or equivalent.
The mating connector also requires three Molex 39-00-0031
terminals or equivalent.
B-10