Specifications

Getting Started
STD ROM Cable Requirements
A serial link is required for the STD ROM system between frontplane
connector J1 and the IBM PC or compatible. The cable shipped with
the STD ROM system should be used for this purpose. Plug this cable
into connector J1 of the ZT 8809A.
The IBM AT requires an adapter cable for its serial port with a
25-pin male D-type connector on one side and a 9-pin female D-type
connector on the other. The Ziatech part number for this adapter cable
is ZT 90026.
STD ROM Jumper Configuration
The following jumper configuration should be used for STD ROM.
Refer to Figure 2-1 on page 2-8 for a visual representation of this
jumper configuration.
INSTALL: W2, 3, 4A, 5B, 6A, 7B-10B, 11A, 12, 13A, 14, 15B,
17B, 18B, 19, 20, 21B, 22-34, 35A, 36A, 37, 38B,
44A (top post) to left post of 40, left post of 41 to left
post of 42, right post of 42 to 43A (right post), 43B,
44B, 45B, 47B, 48, 49A, 50A, 52-57, 59-61, 63,
64B, 65A, 66, 68B, and a wire across the positive
and one of the negative battery terminals (where no
battery is installed).
REMOVE: W1, 4B, 5A, 6B, 7A-10A, 11B, 13B, 15A, 16, 17A,
18A, 21A, 35B, 36B, 38A, 39, 44A, 45A, 46A, 46B,
47A, 49B, 50B, 51, 58, 62, 64A, 65B, 67, and 68A.
2-10