Specifications

Customer Support
TROUBLESHOOTING
Powering Up STD ROM
If you are having difficulty powering up under STD ROM, be sure the
EPROM, RAM, jumpers, and cable are correctly configured. Check
that the ZT 8809A is installed securely in the STD bus card cage. Be
sure you have attached the D-type connector end of the cable to the
appropriate IBM PC or compatible, or to a terminal.
• Follow these steps to power on the system with a PC or
compatible.
1. Turn on the PC and wait for the DOS prompt.
2. Turn on the STD system.
3. Insert the disk containing the STD ROM/Borland’s Turbo
Debugger in drive A.
4. Type
A:td -r and press the carriage return key.
5. Borland’s Turbo Debugger should come up,
communicating across the VTI link with your STD system.
C-2