User's Manual

2. The inversely-installed router cover and loosened screws may cause incursion of water. The router

cover is directional, please follow the cover ’s right direction to install.

3. Incursion of water; Ensure that the router’s cover isn’t inverse , check whether sealing ring exists

and is correctly installed.

4. Router can’t be load network and distribute signal successfully. Check if the router is correctly

installed on the proposed distribution site ; use the smart key to detect the existence of signal in the

site.

5.Antenna’s signal is relatively low , when the smart key is close to the router , the signal is low. Check

if the antenna is loose, if loose, please tighten the antenna. If the router has been working, but the

signal is still low, please replace the router.

6.The WXLYQ-2_FB UT-NET wireless router vehicle-mounted antenna is difficult to be installed and

fixed on an improper site . Vehicle-mounted antenna is provided with magnetic suction, if the

WXLYQ-2_FB UT-NET wireless router is installed in the switchgear cabinet , the antenna can be

sucked on the cabinet roofing, please insert its other end into the cabinet through the reserved hole on

the top of the cabinet

5.1 Warning

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment .This equipment should be installed and operated with minimum distance 20 cm between

the radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

Note: This equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a commercial environment. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case

the user will be required to correct the interference at his own expense.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.、

changes or modifications not expressly approved by the party responsible for compliance could void

the user's authority to operate the equipment.

Antenna Installation:

WARNING:

It is installer’s responsibility to ensure that when using the authorized antennas in the

United States(or where FCC rules apply),only those antennas certified with producct are used.The use of

any antenna other than those certified with the product is expressly forbidden in accordance to FCC rules

CFR47 part 15.204.The installer should configure the output power level of antennas,according to country