User's Manual

with the serial port and network controller, IV host and other equipments, therefore, in addition to

compliance with the principle of distribution network, it is necessary to consider the installation of

communication cables. It supports two serial communication modes: RS-232 and 422, please

select the proper communication mode as needed.See Figure 2

2. Install the power. -see the above instructions for WXLYQ-1_FB UT-NETwireless router.

Figure2

3. Install the antenna. The same as the WXLYQ-1_FB UT-NETwireless router in 2.1.3.

 Install the WXXTQ-1_FB UT-NET wireless router

1. Select the installation site. Please select the site in accordance with the distribution

principles in Instructions for Debugging of UT-NET Wireless Network. it should be installed

in the center of the entire network.

Figure 3

2. Install the power. The same to the router.

422

232