User's Manual

In case of default, the system has seven selectable operation reasons:

1：Lock fault

2：Maintenance

3：Energency unlock

4：Smart key fault

5：SIS fault

6：Retury key

7：Other reasons

The user can use ▲, ▼,  and  keys to select the operation reasons, the selected is

highlighted in reverse color. Press the “Enter” key to start operation after selection is made.

4.1.2.1.3 Enter Operation

After entering the operating, the system will automatically unlock the cabinet door

locking mechanism, then the user can open the door to start operating, for locking mode,

the system will unlock the key mechanism corresponding to the card position selected by

the user, the user can either remove or return the key, but other keys in their places are

still in the locking mode, the user can not operate them; for non-locking mode, which

key will be removed by the user is not limited by the constraint locking of the system.

After the operation, when placing the key back, if it displays a prompt box on the

interface with buzzing, e.g. the management cabinet displays a prompt box below:

01：Lock fault

02：Maintenance

03：Energency unlock

04：Smart key fault

05: SIS fault

06：Retury key

Select unlock reason

▲ ▼ ：switch