User's Manual

15
Where “ID” is automatically generated by the system, the user can also change it, but the
user ID can not be repeated in the system, otherwise it will pop up a message box “User ID
already exists!” when adding the user. There are three authorities: attendant, technician and
administrator, where the attendant’s permission is the lowest while the administrator’s
permission is the highest, and authorities corresponding to the user permission levels are
shown in the table below:
Attendant Technician Administrator
Browse
√ √ √
Operation
√ √ √
Authorization
√ √
Query User
√ √
User Management
√
User Permission Change
√
Time Setting
√ √
Station Number Setting
√ √
Network Setting
√ √
Mode Setting
√
Key Permission Setting
√
Card default is all zeros, it can not be manually edited, it has to swipe the card to
automatically generate, password initialization will generate a fixed password, and the user
can start operating the device only it has changed the password.
When the user has finished editing, press the “Enter” key to save it, if there are errors or
conflicts in user’s data, the system will pop up an appropriate prompt message box, and it will
be OK when the user carries out changes simply following the prompts; If there is no error in
the data, the system will pop up a message box below, press the “Enter” key to return to the
user interface to continue adding users, and to press the “Esc” key will exit user adding and
return to the user management menu.
Explanations are given on the buttons below:
Continue
create
account?