User's Manual

7
Chapter 3 Functional Operation of the Management
Cabinet
The following is an introduction of the operating methods of the UT-059B
_UL key
management cabinet (hereinafter referred to as the “device”).
3.1 System Start
It shall turn on the system power supply, then press the power button for about two
seconds to start the system, in case of an unexpected blackout, if the power is turned on, the
device will automatic start, and without external power but with battery power, to press the
power button about two seconds can also start the device. After the power is turned on about 2
seconds, the LCD display enters the boot interface, and screenshot is shown below:
(1) In the boot interface, if the user does not carry out any operation, the system will
automatically enter the main interface after 10 seconds.
(2) In the boot interface, in the case of any key operation or swiping card, the system will
immediately enter the main interface.
3.2 The Main Interface
The figure below is a typical main interface equipped with the network authorization: