User's Manual

User Manual for iKeyMU-1_F Smart Key
21
If the smart key doesn’t check the correct connection, the smart key displays the
following image to inform the operator that the current device is not switched, please
check it, then the operator must check if the current device is in the correct position, if the
device is not in the required position, please find the reason, and switch the device to the
correct position, then press the Unlocking button on the smart key, the smart key can
continue to show the next operation, then the operator may continue the next operation.
5.5 Post Back
The data postback is a transmission process of the operation processes and results
and other information from the smart key to the mimic panel, (or integrated operating
panel, etc.) which is mainly divided into three types: the normal postback at the end of an
operation, suspension postback during operation process, recalling information postback.
5.5.1 Normal Postback
When the key completes the current operation order, it will automatically prompt the
postback information on the completion of operation, Under the UT-NET communication
mode, the key prompts the information such as “connecting to the wireless network, GET
MAC ...,” when the UT-NET initialization is completed, it can directly prompt the message
“waiting for the postback data.” If the key is closed before postback, it can prompt such
information again automatically when it restarts; the normal postback interface is shown