User's Manual

The product can only be used safely in the non-tropical areas at an altitude no higher than 2000 meters.
Safety Precautions
Laser Safety
The laser radiation is harmful to the human body. Since laser components are completely sealed in the printer, laser radiation will not
leak. To avoid laser radiation, please do not randomly disassemble the printer!
The printer follows the provisions of Class 1 laser products under CFR standard. The printer has a Class III b laser diode, which has
no laser radiation leakage among laser components.
The laser components shall complies with the requirements of: U.S. Code of Federal Regulations, 21 CFR 1040, IEC 60825-1.
The following label is attached to the laser components inside the printer:
Safety Warning
Please note the following safety warnings before using the printer:
Warning
There is high-voltage electrode inside the printer. Before cleaning the printer,
make sure the power is turned off!
Plugging and unplugging the power cord plug with a wet hand can result in an
electric shock.
The fuser unit is hot when and after printing. Touching the fuser unit (the shaded
area as shown) may cause burns!
The fuser unit is attached with a high temperature warning label. Please do not
remove or damage this label.