User Guide

Table Of Contents
130
14.3. Error Message
Error Message
Cause
Measure
No Laser Toner
Cartridge Detected
The laser toner cartridge is
installed incorrectly or laser
toner cartridge is damaged.
The laser toner cartridge is installed correctly
or new laser toner cartridge is replaced.
Toner Low (this
prompt is displayed
together with the
standby picture
alternately.)
The toner in cartridge runs low.
Please replace with a new toner cartridge.
As the toner is low, it
is not available to
accept the printing
job (this prompt is
displayed together
with the standby
picture alternately.)
If the toner in cartridge runs low,
the printing of fax job received
cannot be executed. (Normal in
fax sending, file printing,
copying and scanning.)
Please replace with a new toner cartridge or
find out the " Low in Toner, Continue to Print"
option among the fax receiving setting options
and then set it as "On" for continuous printing.
(Note: once the printer detects that the toner
in cartridge doesn't run low during
booting or opening and closing its cover, it will
set the "Low in Toner, Continue to Print"
option enabled before by user back to “Off”.)
Toner cartridge life
expired.
The toner in cartridge runs out.
Please replace with a new toner cartridge.
Feed jam
The print paper is loaded
incorrectly. The paper is outside
of the specification range.
Please correctly load the print paper.
Printer paper jam
The print paper is loaded
incorrectly.
Please correctly load the print paper.
Scanner is Busy
With other scan jobs.
Please cancel the current scan job or wait for
the completion of other scan jobs.
Scan failed
Scanner internal failure.
Please contact Pantum Customer Service.
No paper in ADF
If you have selected ADF as the
scan source, this message
appears when you start a copy
or scan job without loading
paper in the ADF.
Please put in the original properly.
Paper jam occurred
on ADF
This prompt appears when
there is a feed jam or feed
failure in copying or scanning
with the ADF.
Please remove the paper jam, arrange well
and put originals into the ADF for scanning
again.
Note
• If the problem remains, please contact Pantum Customer Service.