User's Guide
Table Of Contents
- Preface
- Legal Notice
- Safety Precautions
- Precautions
- Regulatory Information
- Table of Contents
- 1. Before Using the Printer
- 2. Paper and Print Media
- 3. Driver installation and uninstallation
- 4. Wired Network Settings (For wired network printer models)
- 5. Wireless network setup (applicable to Wi-Fi models)
- 6. Mobile Print (for models with Wi-Fi function only)
- 7. Print
- 8. Control Panel
- 9. Routine Maintenance
- 10. Troubleshooting
- 11. Product Specification
46
Note：
• Encryption method:
1) None: There is no encryption method used.
2) WPA/WPA2: it is the pre-shared key (PSK) of Wi-Fi protected access which
connects wireless device and access point via TKIP or AES encryption
(WPS-Personal). The working length of WPA/WPA2 is within the PSK of 8-63
characters.
• The display password is not ticked by default; if it is ticked, all passwords input can be
seen in clear text.
• Some models can automatically match the encryption method, no manual selection is
required.
2.2 The computer is not connected to wireless network Input the SSID (case sensitive) and
password of access point (wireless router) in the interface below. Complete configuration according
to interface prompt.
Note：
• If you do not know the SSID of access point (wireless router), please click “Print
Wireless Network Information Page” to view the SSID of the needed access point
(wireless router).
• If the printer cannot be used normally after wireless network setup is finished, please
install the drive again.
3. Use WPS connection .
Select “No, I don't have a USB cable” in the interface below and then click “Next”.