User's Manual

Introduction

Thanks for choosing the Oplink’s wireless PIR motion sensor of the home security device.

This sensor monitors movement, and send signal when movement is detected inside the

building. System comes with pet mode build inside for optional function.

Product Description and Specification

*** For indoor use only ***

Specification: Package Content:

Frequency Range: 433.92MHz

Operating Range: Up to 100 feet line of sight

Operating Temp.: -15°C~ 40°C (5°F~104°F)

Battery: Panasonic CR123A * 1PC

1pc

PIR1301 sensor

Adhesive tape for sensor

CR123A Lithium Battery

Installation & Operation

Manual

Installation

1. Release cover tab to open the cover.

2. Before insert the CR123A battery, user shall decide whether this device need to be

activated when “Stay arm”. In normal case, PIR will not activate when user stay at

home while arm the system. However, some area user won’t even entry, so PIR1301

will let user to choice whether PIR1301 should activated while stay arm.

Hold tamper switch on PIR1301 while insert the CR123A battery, if LED flash twice, it

means this PIR Senor won’t activated while system at Stay Arm stage. If this is not

the function you want, please remove battery, then hold tamper switch & insert battery

again. Then LED shall flash three times, it means this PIR Sensor will activated all

the time at Stay Arm or Away Arm stage.

-1-

3. Close the cover back to sensor.

4. To home security controller into learning mode. Press “Program Switch” on the back

of PIR1301 to learn device into system.

5. Using adhesive tape to mount PIR1301 at 2 meters above surface. To enhance

proper operation, place PIR1301 on the angle which can detect the room widely. The

solid area means the detector’s coverage range.

Operation

1. Walk in front of PIR1301, sensor will send the signal to system, and the LED will flash

five times.

2. Normal operation, the LED will not light.

3. The PIR1301 sensor equipped with tamper switch. If the cover of sensor is removed,

the PIR sensor will report a zone tamper to the controller, and the LED will flash five

times.

4. If pet in house, user can choice “pet mode”. Please refer to Product Description and

Specification for installation.

5. If PIR motion sensor is in low battery status, it will report a message to controller, and

LED will flash slow. Please change the battery.

-2-