User's Manual

Oplink Communications
After configuration complete, the AP works as a
wireless signal repeater. You can connect the device to
computer, satellite receiver and IPTV set-top box and you
need to set them to obtain IP address automatically to
access the source wireless device (source wireless router).
Detailed settings refer to the Appendix I.
5.4 WISP Mode
Log on the web-based interface as chapter 4 and then
configure the mode as below.
5.4.1. Select “WISP”, click “Setup Wizard” and “Next”
button.
5.4.2. Configure the parameters
 SSID：SSID (Service Set Identifier) is the unique
name of the wireless network. Input the SSID of the
aimed AP.
 MAC Address: The Router’s physical MAC address
as seen on your local network is unchangeable. Input
the MAC address of the AP you want to choose.