User's Manual

IPCAM User Manual

8.3.6 Why pop-

This prompt only appeared in the case of using multiple cameras.

Enter the Multi-Device Settings page(login as administrator) to check the

Device setting is correct or not.

When one of the multiple cameras disconnected, the color changed to

yellow and pop-

Picture 121

8.3.7 access the IPCAM in the internet?

There are some reasons:

1 ActiveX controller is not installed correctly(see more details:5.1.4).

2 The port IPCAM used is blocked by Firewall or Anti-virus software. Please change a

port number and try again.

3 Port mapping is not success. You can do port mapping by two ways:

.Enter setting page of the router which IPCAM connect with to enable UPnP function.

the Virtual Map function. Enter router setting page, add IPCAM s IP

and port to the Virtual map list.

When use ADSL, the IP is dynamic. You should set DDNS(see more details 3.5.4 & 5.1.6)

and also make sure port mapping success.

8.4 Operate common problem solving

Except of the camera broken

1. Make sure the cable connector no problem, recommend connector