User Manual

Introduction
Thanks for choosing the OPLINK Garage door sensor of the home security device. This
sensor monitors garage door open / closes status and send alarm report signal when
angle is changed.
Product Description and Specification
*** For indoor use only***
Specification:
Package Content:
Frequency: 433.92MHz
Operating Range: Up to 100 feet line of sight
Operating Temp.: -15°C~ 60°C (5°F ~140°F)
1pc
1pc
2pc
3pcs
1pc
1pc
GDS1300 Sensor
Bracket Holder
Adhesive tape for detector
Screw for bracket
CR123A Lithium Battery
Installation & Operation manual
Status/ Signal (Alarm report)
Alarm Type
Open Alarm
1111 0010 1001
100X
Close Alarm
1111 0010 1001
101X
Temper Alarm
1111 0010 1001
111X
Low Battery Alarm
1111 0010 1001
110X
Heart Beat
1111 0010 1010
001X
Installation
Notice: If you are installing the entire OPLINK Garage door sensor for the first time,
please refer to the installation guide of OPLINK Garage door sensor.
1. Install Battery: Use care when installing the battery. Press the locking tab on the top
sensor cover, and then gently pull up the cover. Observe the correct polarity before
insert the battery.
2. After insert the battery, the LED will start to flashing, which means the sensor has
monitors garage door open / close status and send alarm report signal.
3.
Slide back the rear cover and screw fastening with the front cover.
4. Using the adhesive tape or fixing screws to fix the bracket holder with garage detector.
For better operation, please install detector on top portion of garage door.
-2-