User's Manual

Introduction
Thanks for choosing the Oplink wireless door/window sensor of the home security device.
This sensor monitors door/window when door or window is opened and closed.
Product Description and Specification
*** For indoor use only***
Specification:
Package Content:
Protocol: 433.92Mhz
Operating Range: Up to 200 feet line of sight
Operating Temp.: -15°C~ 60°C (5°F ~140°F)
Battery: Panasonic CR123A * 1PC
1pc
1pc
1pc
2pcs
1pc
4pcs
1pc
Dwm1301 sensor
Bracket for Contact Magnet
Magnet
Adhesive tape for Magnet /
sensor
CR123A Lithium Battery
Screws for bracket/ sensor
Installation & Operation manual
Installation
1. Unscrew the screw fastening the rear cover.
2. Slide the rear cover down.
3. Using the screws or adhesive tape to affix the rear cover on the frame along the opening
edge of door / window.
4. Before insert the battery, put home security controller into learning mode. Once put on
CR123A battery into the battery compartment and LED will flash 5 times, and HD 2102
door/window sensor will automotive included into system.
5. Slide back the rear cover and screw fastening with the front cove.
6. Fix the Magnet by using the adhesive tape or fixing screws, locate the Magnet close to the
DWM1301 sensor the distance between these two devices should be in 1.9cm.
-1-
7. External Switch: If your window needs two sensors for fully monitoring. You could use an
external switch to connect with the DWM1301 for extending detection. The DWM1301 has 2
normally closed contact terminals. These can be used for additional external switch wired
contacts. The external switch will send an alarm report by opening the window/door.
Operation
1. Opening the door/window to separate the magnet from the sensor will send signal to the
controller, and the LED will flash 5 times
2. Normal operation, the LED will not light.
3. The DWM1301 sensor equipped with tamper switch. If the cover of sensor is removed, the
door sensor will report a zone tamper to the controller, and the LED will flash 5 times.
4. If door/window sensor is in low battery status, it will report a message to controller, and
LED will flash slow. Please change the battery.
-2-