Product Specs

珠海顶智电子科技有限公司
http://www.qualmodule.com/
Type: PCB Antenna
Gain: 1 dBi
The module can be used for mobile or applications with a maximum 1dBi antenna. The host
manufacturer installing this module into their product must ensure that the final composit
product complies with the FCC requirements by a technical assessment or evaluation to the FCC
rules, including the transmitter operaition. The host manufacturer has to be aware not to
provide information to the end user regarding how to install or remove this RF module in the
user's manual of the end product whichintegrates this module. The end user manual shall
include all required regulatory information/warning as show in this manual.
2.4 Limited module procedures
Not applicable.
2.5 Trace antenna designs
Not applicable. The module has its own antenna, and doesn ’ t need a host ’ s printed board
microstrip trace antenna etc.
2.6 RF exposure considerations
The module must be installed in the host equipment such that at least 20cm is maintained
between the antenna and users ’ body; and if RF exposure statement or module layout is
changed, then the host product manufacturer required to take responsibility of the module
through a change in FCC ID or new application. The FCC ID of the module cannot be used on the
final product. In these circumstances, the host manufacturer will be responsible for
re-evaluating the end product (including the transmitter) and obtaining a separate FCC
authorization
2.7 Antennas
Antenna Specification are as follows: