Product Specs

珠海顶智电子科技有限公司
http://www.qualmodule.com/
Not applicable.
2.5 Trace antenna designs
Not applicable. The module has its own antenna, and doesn’t need a host’s printed board microstrip trace antenna etc.
2.6 RF exposure considerations
The module must be installed in the host equipment such that at least 20cm is maintained between the antenna and
users’ body; and if RF exposure statement or module layout is changed, then the host product manufacturer required to
take responsibility of the module through a change in FCC ID or new application. The FCC ID of the module cannot be
used on the final product. In these circumstances, the host manufacturer will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate FCC authorization
2.7 Antennas
Antenna Specification are as follows: Type: PCB Antenna
Gain: 1 dBi
This device is intended only for host manufacturers under the following conditions: The transmitter module may not be
co-located with any other transmitter or antenna; The module shall be only used with the internal antenna(s) that has
been originally tested and certified with this module. The antenna must be either permanently attached or employ a
‘unique’ antenna coupler.
As long as the conditions above are met, further transmitter test will not be required. However, the host
manufacturer is still responsible for testing their end-product for any additional compliance requirements required with
this module installed (for example, digital device emissions, PC peripheral requirements, etc.)
2.8 Label and compliance information
Host product manufacturers need to provide a physical or e-label stating “Contains Transmitter Module
FCC ID: 2ATZK-DZ-I5005” with their finished product.
2.9 Information on test modes and additional testingrequirements BLE
Operation Frequency: 2402~2480MHz Number of Channel: 40
Modulation: GFSK
WIFI
Operation Frequency: 2412~2462MHz Number of Channel: 11
Modulation: DSSS
Host manufacturer must perfom test of radiated & conducted emission and spurious emission, etc according to the
actual test modes for a stand-alone modular transmitter in a host, as well as for multiple simultaneously transmitting
modules or other transmitters in a host product. Only when all the test results of test modes comply with FCC
requirements, then the end product can be sold legally.
2.10 Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for FCC Part 15 Subpart C 15.247 & 15.207 & 15.209 and that the host
product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the
modular transmitter grant of certification. If the grantee markets their product as being Part 15 Subpart B compliant
(when it also contains unintentional radiator digital circuity), then the grantee shall provide a notice stating that the final
host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed