Spec Sheet

ZY8266-12 Spec V1.0

Page 17 of 18

or module layout is changed, then the host product manufacturer required to take

responsibility of the module through a change in FCC ID or new application. The

FCC ID of the module cannot be used on the final product. In these circumstances,

the host manufacturer will be responsible for re-evaluating the end product

(including the transmitter) and obtaining a separate FCC authorization.

2.7 Antennas

Antenna Specification are as follows:

Type: PCB Antenna

Gain: 0dBi

This device is intended only for host manufacturers under the following

conditions:

The transmitter module may not be co-located with any other transmitter or

antenna;

The module shall be only used with the internal antenna(s) that has been

originally tested and certified with this module. The antenna must be either

permanently attached or employa unique antenna coupler.

As long as the conditions above are met, further transmitter test will not be

required. However, the host manufacturer is still responsible for testing their

end-product for any additional compliance requirements required with this module

installed (for example, digital device emissions, PC peripheral requirements,

etc.).

2.8 Label and compliance information

Host product manufacturers need to provide a physical or e-label stating

“Contains FCC ID: 2A9JH-ZY8266” with their finished product.

2.9 Information on test modes and additional testing requirements

Operation Frequency: 802.11b/g/n 20: 2412~2462 MHz

Number of Channel: 802.11b/g/n20: 11CH

Modulation:

802.11b(DSSS):CCK,DQPSK,DBPSK

802.11g(OFDM):BPSK,QPSK,16-QAM,64-QAM

802.11n(OFDM):BPSK,QPSK,16-QAM,64-QAM