Spec Sheet

ZY8266-12 Spec V1.0

Page 14 of 18

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept

any interference received, including interference that may cause undesired

operation.

Any Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

If the FCC identification number is not visible when the module is installed

inside another device, then the outside of the device into which the module is

installed must also display a label referring to the enclosed module. This

exterior label can use wording such as the following: “Contains Transmitter

Module FCC ID: 2A9JH-ZY8266 or Contains FCC ID: 2A9JH-ZY8266”

When the module is installed inside another device, the user manual of th e host

must contain below warning statements;

1. This device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference

that may cause undesired operation.

2. Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

The devices must be installed and used in strict accordance with the

manufacturer's instructions as described in the user documentation that comes

with the product.

Any company of the host device which install this modular with Single modular

approval should perform the test of radiated emissionand spurious emission

according to FCC part 15C: 15.247 and 15.209 requirement, Only if the test result

comply with FCC part 15C: 15.247 and 15.209 requirement, then the host can be

sold legally.