User's Manual

Initial Start-Up

Insert the Batteries

Open the battery door in the back of the scale.

Remove insulating strip from beneath the battery

(if fitted) or insert batteries (3 x 1.5V AAA)

observing the polarity signs (+ and -) inside the

battery compartment.

Close the battery door and wait until the digits

“0.0kg” are shown on the LCD.

Transtek Body Fat Analyzer GBF-1714-F applies BIA (Bio-impedance Analysis)

technology. A small amount of weak current flows through the human body so as to detect

the bio-impedance and estimate BMI, body fat, body water, muscle mass, bone mass and

BMR. The electrical current is small and may not be felt.

This BIA technology is cheap, safe, non-invasive, toxic-free and harmless. It also

possesses the characteristics of simple operation and abundant information.

The current mentioned above is less than 0.5mA. However, please be aware that

anyone with an wearable or implantable medical electronic instrument, such as a

pacemaker, must avoid using this device.

The intended use of this device is for healthy children 10-17 years old and healthy

adults.

General Instructions

CAUTION

When the symbol “ ” appears, the device will power off in about 4s. Then you shall replace with a new

set of batteries. Please replace all three batteries at the same time. Do NOT mix the old batteries with the

new one.

Worn batteries are hazardous waste. Do NOT dispose of them together with the household garbage.

Please refer to the local ordinances and recycling instructions regarding disposal of the worn batteries

and scrapped device.

If you do not intend to use this unit for a prolonged period of time, it is advisable to remove the batteries

before storing.

Configure the Wi-Fi Password

1. Install the App “Smart Life”. This App could be freely downloaded at the APP Store,

you may search and install it in your smartphone.

2. Register an account. Then follow these steps:

3.Then long press the button in the back of the scale, the icon and icon will

be shown on the LCD alternatively, and the Wi-Fi icon blinks as well, indicating

configuration is proceeding.

Select Measurement Unit

After the Wi-Fi password is configured successfully, you can select measurement unit

through pressing the unit button back of the scale. You can choose kilogram, pound

and stone as your measurement unit.

Note: Take the latest version of APP as the criterion.