User's Manual
9
8
The body fat analyzer GBF-1406-B supports multiple users (Up to 8). You may follow
below instructions to assign User ID and set up your own profile, including Gender,
Stature, and Age.
Initial Start-Up
Initial Start-Up
Set Up Your Profile
Select Measurement Unit
After confirming User ID, the system will divert to Gender setting automatically.
As pictured below, the portrait blinks. The operator may press the function key
or to select Gender.( Male/Female/Male Athlete/ Female Athlete).
Press “SET” key to confirm Gender.
With batteries correctly installed, press “SET” key to enter setting mode when
the scale is off. Or when the LED displays 0.0, press and hold “SET” key to
enter setting mode.
The system will request User ID selection first. As pictured below, “P1” blinks.
The operator may press the function key or to select User ID among P1
to P8.
Press “SET” key to confirm User ID.
1.Assigning User ID
2.Setting Gender
With batteries correctly installed, press “UNIT” button in the back of the scale to select
measurement unit. The default measurement unit is “kg”. You may press “UNIT” button to
choose among kilogram, stone and pound.
Weight Only Operation
Your TRANSTEK Body Fat Analyzer will operate as a conventional weight - reading
scale. No special programming steps are required.
Once the scale is initialized, as previously described, you may simply step on the scale
to measure your current weight. For only weight reading.
1. Position the scale on a flat, hard surface. Carpeted or uneven floors may
affect accuracy.
2. Step onto the scale platform and remain still while the scale computes your weight.
3. The scale will display your weight value.
4. The scale will automatically turn off after a few seconds.
1. Press the platform centre and remove your foot.
2. “0.0” will be displayed.
3. The scale will switch off and is now ready for use.
This initialisation process must be repeated if the scale is moved.
At all other times step straight on the scale.
Initialising Your Scale
Note: The weight value won’t be saved in the scale, and won’t be transmitted to the APP.