Specifications

15xx-A1 Family Router Users Guide 37
2. Under Advanced Setup click WAN Service then click Add.
3. On the WAN Service Interface Configuration page, select the DSL link associated with the
bridge interface from the drop down, then click Next
4. On the WAN Service Configuration page, select Bridging
5. On the WAN Service Configuration page, enter a name if you wish to customize the
description shown for the service, then click Next.
6. In the WAN Setup – Summary page, review the settings for this interface. Click Apply/Save
to accept the settings.
If you made a mistake on the configuration and want to make changes to it, select the
Remove check box and click the Remove button.
In the Wide Area Network (WAN) Service Setup page, you will see the new WAN interface
added.
Add a PPPoE WAN Service
1. Add an EoA Layer 2 interface as described above (Add a Layer 2 Interface).
2. Under Advanced Setup click WAN Service then click Add
3. On the WAN Service Interface Configuration page, select the DSL link associated with the
PPPOE interface from the drop down, then click Next
4. On the WAN Service Configuration page, select PPP over Ethernet (PPPoE).
5. On the WAN Service Configuration page, enter a name if you wish to customize the
description shown for the service, then click Next.
6. On the PPP Username and Password page you will need the following information:
 PPP Username: Your account from ISP to access Internet.
 PPP Password: The password assigned by your ISP.
Note: If you set the username/password to default/default, the modem will redirect the user to
a web page within the modem to change their password when they first log on.
 PPPoE Service Name: Server name of network ISP. No need to set.
 Authentication Method: Authentication mode of network ISP. Default is AUTO
 Enable Fullcone NAT: RFC 3489 defines four types of Network Address Translation
(NAT). Fullcone NAT. As with other types of NAT there is a mapping from a public IP
address to a private IP address. The external public IP address is extended with the
external port. With Fullcone NAT once the mapping is created any external host may
send packets to the private IP address by sending to the external IP address and port.
Other types of NAT have restrictions such as the sending IP address must initially have
had packets sent from the private IP address and port regardless of the external port, or
from the private IP address and the external port.
Enable NAT must be checked for Fullcone NAT to be used.
 MAC Clone: Clicking the Clone the PC MAC Address button will use the MAC address
from the connected PC for the MAC address of the router.
 Dial on demand: When this mode is selected, the connection that has no traffic within
assigned disconnect timeout (e.g. 1 minute) will be automatically disconnected. The
connection will be activated again when traffic arrives. This function is advantageous for