Specifications

12
From this screen you can:
Command Line Interface
The network extender can be managed with a Command Line Interface (CLI) through
either a direct PC to DSLAM COM (Communication) Port connection or from a remote
network connection via Telnet.
CLI System Requirements
 Straight-Through RJ45 to RJ45 Ethernet Cable – Required for establishing a
direct connection from the COM port to a DB9 adapter.
 DB9 Female to RJ45 Male Adapter – Required for conversion of your PC’s RS232
serial port for use with the RJ45 to RJ45 Ethernet cable.
 Terminal Emulation Program – Required for running the CLI over a direct
connection. The program must emulate a VT100 terminal.
 Telnet Client – Required for remote management with the CLI. Microsoft Windows
Operating Systems (98, 2000, NT and XP) include a Telnet client which is run using
the Windows command prompt (cmd.exe). If you are using an operating system
other than Windows, you may need to install a Telnet client.
 Trivial File Transfer Protocol (TFTP) Client – Required for downloading firmware
updates and for saving configurations to local files for backup.
Click on . . . To configure . . .
Management Config. IP Address, Subnet Mask, Default Gateway,
Inband Management VLAN ID and Priority
Advanced Config. System Name and Location, Management IP
Address Filter, TFTP and Telnet access
HTTP Password General and Superuser Passwords
SNMP Config. SNMP Notification IP Addresses and SNMP
Traps
SNMP Community SNMP Community Names
Ethernet Connections Lnk/Act LEDs Ethernet Duplex Mode and Speed
T1 Connections Lnk/Alm LEDs T1 Data Rate, Frame Type, Line Code,
Tx Buildout, and Clock Source