Instruction manual

Connecting the Ethernet Line

Procedure

1. Plug the Ethernet cable into the Ethernet Connection RJ45 port on the back of the

SNE2000G.

2. Verify the connection: solid illumination of the Ethernet Connection Lnk LED on the

front of the SNE2000G indicates a link has been established, if an SHDSL

connection has already been made. If an SHDSL connection has not yet been

made, the Ethernet link will remain disabled (as indicated by solid illumination of the

Ethernet Rx, Tx and Lnk LEDs) until the SHDSL link has been established.

NOTE: For most applications, the SNE2000G connects to a PC using a straight-through

Ethernet cable and to a hub or a switch using a crossover Ethernet cable.