Specifications

4-10 General Features
Model No.
Running Head
User Screens and Settings IMACS-200 General Features
11. From the SYS port Main screen in Figure 4-2, enter ‘I’ for tcp/Ip, as seen in figure Figure
4-6.
Figure 4-6.Setting up the Ethernet Port
12. Leave the HOST IP STATE as stdby for now.
13. Enter in the HOST IP ADDRESS: [device IP address]
14. Enter in the HOST NETMASK: [IP mask]
15. Select the HOST TYPE as either host or gateway.
16. Select the DEFAULT IP TYPE as either none, local ethernet or wan
a. If wan is chosen, then the IP SLOT and IP TS will be accessible to the user. If this is
the case, datafill these fields with the WAN and timeslot where the Ethernet port will
be carried. Otherwise, these fields will be n/a by default.
17. Enter in the DEFAULT GATEWAY:[IP address]
18. Save the specified settings.
19. Go back up to the HOST I P STATE in step 2 and change it to actv
20. Save the specified settings.
21. From a PC on the same IP network, enter:
a. Ping [device IP address]
b. Telnet [device IP address]
22. From the IMACS-200:
a. Ping PC on IP network
23. From a PC on a different network than the IP network: