Specifications

6-2 FXS Ports
Model No.
Running Head
Figure 6-1. Typical FXS port Main Screen
The bottom highlighted line of this screen shows various actions that you can perform from
this screen. You perform the desired action by pressing the associated uppercase letter key.
Table 7-1 summarizes these actions. For example, after you configure the FXS port ports,
press “s” to save your settings.
Table 7-1summarizes the configuration settings for the FXS ports, along with the available
and factory-default option settings. The parameters and settings are also described in the
following paragraphs.
Table 6-1. Main Screen Option Settings and Defaults
STATE
The State setting determines whether the port is active or inactive. An inactive port does not
occupy a time slot on a WAN link. Set the State setting to stdby (standby) for ports that are
not to be used or that have not yet been configured. Set it to actv (active) for ports that are
ready for use.
Parameter User Options Notes Default
STATE stdby actv stdby
WAN/SRV none wan none
TS 01-24 01
MODE fxs fxs
Rx TLP -9.0 dB to +3.0 dB -2.0
Tx TLP -9.0 dB to +3.0 dB 2.0
CODING u-law a-law u-law
LB off dgtl anlg off
PATTERN none D-mW none