Specifications

3-38 Reference Guide
Model No.
Running Head
Cross-Connecting WAN Time Slots System Configuration and Operation
WARNING!
When cross-connecting multiple independent data DS0 time slots (sequential
grouped time slots should work) for data. (Supergroup is multiple DS0’s
sequentially assigned) between WAN aggregates in a cross-connect system.
DO NOT attempt to save time by cross-connecting independent data time slots
as one super-rate circuit (could cause data errors.) This limitation does not
apply to voice time slots.
Figure 3-24. New Circuit Selection and ID Assignment
W/U
The first WAN Unit column is the T1/E1 link in which the pass-through connection begins
(since these circuits are bi-directional, the concept of beginning or ending is used for
illustrative purposes only). The options are all WAN cards and ports, and the identification
uses the same convention (
w1-1, w1-2, etc
.) seen earlier. If a WAN card is not present in the
W/U selected, an error message is generated. The example in Figure 3-25 shows
w1-1
(WAN
1, port 1) as the selected WAN card and port.
Node_1 | C1 CPU-3 XCON Rev A0-0 Ser 00101 | 12-31-99 14:33
page: 1 of 1
CIRCUIT ID W/U TS/BW TEST W/U TS/BW TEST TYPE TC CNV
new_circuit w1-1 00*64 off w1-1 00*64 off d n/a n/a
SF01-NY01
Save