Specifications

Reference Guide 3-29
System Configuration and Operation Assigning Time Slots to a User Card
4. Set the time slot number by using the up and down arrow keys to highlight it, then press
the <Enter> key.
5. Change the STATE of the port from
stdby
to
actv
.
6. Repeat steps 2 through 5 for the remaining card ports, to assign time slots to them.
7. Press “
s
” to save your settings, using the
Save
command in the Card Main Screen.
Figure 3-16. Typical E&M Card Time Slot Assignments
3.10.2 Assigning Multiple Time Slots to a Port
Figure 3-17 shows the HSU Card Main Screen for the example of Figure 3-15. Assign time
slots to this card as follows:
1. From the Main Screen, select the desired HSU card and press <Enter>.
Node_1 | U1 E&M 4Wx8ER Rev A2-0 Ser 01103 | 12-31-99 14:33
1234567 8
STATE actv actv actv actv actv actv actv actv
WAN/SRV w1-1 w1-1 w1-1 w1-1 w1-1 w1-1 w1-1 w1-1
TS 01 02 03 04 05 06 07 08
MODE e&m e&m e&m e&m e&m e&m e&m e&m
R2 TYPE n/a n/a n/a n/a n/a n/a n/a n/a
RX TLP 0.0 0.0 0.0 0.0 0.0 0.0 0.0 0.0
TX TLP 0.0 0.0 0.0 0.0 0.0 0.0 0.0 0.0
CODING u-law u-law u-law u-law u-law u-law u-law u-law
TC CGA idle idle idle idle idle idle idle idle
LB off off off off off off off off
PATTRN none none none none none none none none
HYBRID n/a n/a n/a n/a n/a n/a n/a n/a
SIG CONV off off off off off off off off
RATE 64k 64k 64k 64k 64k 64k 64k 64k
ADPCM n/a n/a n/a n/a n/a n/a n/a n/a
Save | Undo | Refresh | Copy | Test | Main