Specifications

Reference Guide 3-21
System Configuration and Operation Zipping the System
Figure 3-11. Zip Screen
3.7.1 Debugging the System
The
D
(Debug) command is only available to factory software engineers with a password
authorization higher than "Superuser." It gives access to the system software coding.
3.7.2 Registering the System
The
R
(Registration) command allows a user with Operator or higher password authority to
change the registration of the system. The original registration is explained earlier in this
chapter. You must have this information to properly re-register the system.
Do not use this
command during normal system operation.
The registration procedure consists of three steps. First, you must enter the vendor code. Then,
you must select the type of chassis used. Finally, confirmation of the proposed changes is
required (
Y
= yes,
N
= no).
Test and Debug
Zip will reboot the system. Ok to Zip (y/n)?
Zip | Debug | Reg | Backup | rEstore | Main