Specifications

3-14 Reference Guide
Model No.
Running Head
Alarms and Alarm Filters System Configuration and Operation
The third entry (
CSU + CSU
) shows the type of card affected (in this case, a WAN card with
two T1 CSU modules).
The fourth entry shows the alarm modifier (in this case,
C
indicates a critical alarm). See the
“Alarms and Alarm Filters” section later in this chapter for more information about alarm
modifiers.
The fifth entry (
CGA_RED
) shows the type of alarm generated (in this case, a CGA-Red
alarm on WAN port W1-1).
The last two entries show the date and time the alarm was logged (in this case, December 31,
1999, at 11:59:59 a.m.).
3.5.1 Alarm Filter Settings
You can set filters for each alarm so that the alarm reports occurrences in a number of different
ways. Figure 3-9 shows the Alarm Filters screen, which is accessed by pressing "
f
" (
Filters
command) on the Alarm Screen.