Specifications

Reference Guide 3-7
System Configuration and Operation Basic Screen Map and Legend
Table 3-2. System Main Screen Actions
3.3.3.2 Voice and Data Card Status
The System Main Screen also shows you the status of the individual circuit ports of all Voice
and Data cards in the system. This information appears next to the card type, as shown in
Figure 3-5. The lowercase letters in the Status column fields indicate the states of the
individual card ports. The possible values for each port are
s
(Standby),
a
(Active),
t
(Test),
l
(currently in a Loopback state), and
r
(on a Redundant WAN card).
Action Function
Alarms Brings up the Alarm Screen. Refer to "Alarms and Alarm Filters” later in
this chapter.
Config Sets up the system using a standard configuration.
Del Removes an out-of-service (OOS) card from system memory.
accepT Removes the current card settings. Used when replacing a card in any slot
with a different kind of card.
Xcon Brings up the cross-connect screens.
sYs Brings up the system screen for high-level system testing and maintenance.
Logout Logs you off the system.
Oos Allows authorized operators to take cards out of service.
cpusWtch Switches from the active CPU card to the redundant CPU card, if the system
is configured for CPU redundancy.