Specifications

B-14
Reference Guide
Model No.
Running Head
Profile has to be loaded first.
You cannot use the Dial command in the HSU Card Main Screen without first loading a call
profile.
Profile Id was not found.
Upon using the Load command in the HSU Card Main Screen, you requested a non-existing
call profile from the Interface card.
RATE = 19.2 must have DATA = 8 for adpcm or hlink.
If you set the SRU card port rate to 19.2 kbps, you also must set the number of data bits for
that port to 8.
Redundancy requires WAN Model 8014 in Slot W4.
Your system must have an 8014 WAN Card in slot W4 for WAN redundancy operation.
Redundancy switchover is complete.
You have asked the system to switch to the redundant WAN card, and the switchover was
successfully completed. (This is not an error message; it normally appears after you initiate
the switchover.)
Redundant CPU.
The current CPU card is the redundant card.
Redundant WAN is taken already.
You cannot switch to the redundant WAN card in slot WAN-4 if it is already in use from a
previous WAN card switch.
Remote session active. Can’t change setting.
You cannot change this setting because a remote operator has accessed the system and is
controlling it. Wait for that operator to log off and disconnect.