Specifications

Reference Guide 6-15
WAN Card WAN Card User Screens and Settings
Table 6-3. T1 CSU and DSX Option Settings and Defaults
Notes:
1. Valid options for Bus Connect systems are
term
and
d-i
. The only valid option for
Cross-Connect systems is
xcon
.
2. These options are valid only if you have a CSU and the Line Code is
ami
. If you have
a CSU and the Line Code is
b8zs
, then this setting will default to
n/a
. If you have a DSX
module, then this setting will always default to
n/a
.
3. These options are valid only if you have a CSU. If you have a DSX module, then the
possible options are
0
(default),
133, 266, 399, 533, 655
, and
csu
.
4. The settings for AIS/ALM vary greatly by the settings of other parameters.
5. If the format is d4 or slc96, the only option to appear will be
none
.
6. If there is no redundant WAN card in the appropriate slot the only option that will
appear is
n/a
.
7. Selection of GROUP is a two-step process. After identifying the group number (1-4),
the user must select the secondary group (A, B, or C). At which point TC ODR will then
become available.
Parameter User Options Notes Default
STATE stdby actv stdby
MODE term d-i xcon 1 xcon
FORMAT d4 esf slc96 slcd4 esf
LINE CODE ami b8zs 2 b8zs
PULSE n/a trnsp z15s n/a
LINE LEN 0 7.5 15.0 3 0
SLIP LIM 126 138 126
AIS/ALM none tcodr 4 none
LINE LB off on off
LOCAL LB off on off
CH LB off clr off
LB ADDR 01-24 01
LB GEN off llb plb nlb off
LB DET w/to off on w/to
ESF/NMS RP none at&t ansi both c-fdl c-b7r e-fdl 5 at&t
EER THRHD 10e-4 thru 10e-9 none 10e-4
RDNT RULES n/a none OOS CGA 6 none
GROUP none 1 2 3 4 7 none