Specifications

Reference Guide 6-13

WAN Card WAN Card User Screens and Settings

6.2.9 Installing the WAN Cards

After installing the proper modules on the WAN cards, insert the WAN cards into the system

chassis. Each system can have up to four WAN cards, which go into slots W1 through W4.

For a system with redundant WAN cards, always insert a WAN-R card into slot W4. If you

install the WAN-R card into any other WAN card slot, it will work as a regular WAN card (not

as a redundant card). Also make sure that the WAN-R card has the same types of modules

installed on it as the associated primary WAN cards, and that those modules are installed in

the same positions (ports 1 and 2), as shown in Figure 6-1

6.3 WAN Card User Screens and Settings

6.3.1 T1 CSU and DSX Settings

The DSX/CEPT and CSU Modules for T1 operation have identical configuration parameters,

which you must set on, the WAN Card Main Screen. To go to that screen, select the desired

WAN card on the System Main Screen, then press <Enter>. Figure 6-20 shows a typical WAN

Card Main Screen for T1 CSU or DSX operation.

Figure 6-20. WAN Card Main Screen for T1 CSU or DSX

Node_1 | W1 CSU+DSX Rev A6-2 Ser 00101 | 12-31-99 14:33

CSU DSX

STATE stdby STATE stdby

MODE xcon MODE xcon

FORMAT esf FORMAT esf

LINE CODE b8zs LINE CODE b8zs

PULSE n/a PULSE n/a

LINE LEN 133 LINE LEN 133

SLIP LIM 126 SLIP LIM 126

AIS/ALM none AIS/ALM none

LINE LB off LINE LB off

LOCAL LB off LOCAL LB off

CH LB off CH LB off

LB ADDR 01 LB ADDR 01

LB GEN off LB GEN off

LB DET w/to LB DET w/to

ESF/NMS RP at&t ESF/NMS RP at&t

EER THRHD 10e-4 EER THRHD 10e-4

RDNT RULES n/a RDNT RULES n/a

GROUP none GROUP none