Specifications

5-18 Reference Guide
Model No.
Running Head
Interface Card User Screens and Settings Interface Card
Figure 5-12. Typical Ports Screen (INTF+M)
This screen shows the Protocol, Rate, Communications, and Handshaking control settings for
each port. The VT column lists the current settings for a VT100-compatible terminal
connected to the TERM modular jack on the Interface card faceplate. The C1 column is for an
external computer connection to the COMP (or COM1) DB-9 plug on the card. The M column
is for a modem connection from an INF+M card to a remote facility via a phone line.
The screen settings are described in the following paragraphs.
Note:
There are two scenarios in Figure 5-12. The Typical INTF+M Ports Screen shown
above displays (VT - VT100 terminal, C1 - COM1, and M-Modem). However, if
INTF+E isn’t used the screen will display (VT, C1, and C2 - COM2).
PROTOCOL
For the VT-100 terminal port, the Protocol setting is always
ui
(user interface).
For the computer (C1) port, choose
ui
,
pr
(Printer),
slip
(Serial Line Interface Protocol), or
ppp
(Point-to-Point Protocol).
Node_1 | IF INF+M T1E1x8 Rev A0-0 Ser 00000 | 12-31-99 14:33
VT C1 M
PROTOCOL ui none ui
RATE 9.6 9.6 2.4
COM CFG 8,1,N 8,1,N 8,1,N
HANDSHAKE none none none
Save | Undo | Refresh | Main