Specifications

4-12 Reference Guide
Model No.
Running Head
TCP/IP Network Management CPU Card
Table 4-5. TCP/IP Screen Parameters and Options
Notes:
1. The user options depend upon the selection in the Default IP Port selection. All user
options are explained below.
HOST IP STATE
This parameter determines whether TCP/IP is active or inactive. The HOST IP STATE
defaults to
stdby
(standby) prior to configuration. You must set it to
actv
(active) to enable
TCP/IP.
HOST ID ADDR
The Host IP Address is the IP address for this specific system unit. If the B7R card is used for
this NMS, the Port IP address must be the same as the one entered in the
ADDR
field of that
card.
HOST NETMASK
The Host Netmask is used to indicate how much of the IP address is used for host addressing
and how much is used for network addressing.
If the B7R card is used for this NMS, the CPU netmask address must be the same as the one
entered in the
NETMASK
field of that card.
Parameter User Options Notes Default
HOST IP STATE stdby actv stdby
HOST IP ADDR IP address 0.0.0.0
HOST NETMASK IP address 0.0.0.0
DEFAULT IP PORT off n/a local wan serv 1 n/aoff
DEFAULT IP SLOT n/a 1 n/a
DEFAULT IP UNIT n/a 1 n/a
RPT1 IP ADDR IP address 0.0.0.0
RPT1 COMMUN STR blank
RPT2 IP ADDR IP address 0.0.0.0
RPT2 COMMUN STR blank
RPT3 IP ADDR IP address 0.0.0.0
RPT3 COMMUN STR blank