Specifications

Reference Guide 4-11
CPU Card TCP/IP Network Management
Figure 4-5. Typical TCP/IP Screen
Table 4-4. TCP/IP Screen Actions
Action Function
Ping Test to see if the connected device responds to an echo request message.
After entering the IP address of the host device, the status line will display,
"Testing . . ." The next message will tell if the host is alive or down.
Netstat Displays the Network Statistics. See below.
rOute Shows the Routing screen. See the “Routing” section below.
Save Saves changes to settings.
Undo Returns all settings to the last saved state.
Refresh Used on Testing and Monitoring screens to update statistics, and on other
screens to redraw the screen.
Main Returns to the CPU card main screen. If changes are made to settings and
not saved, you will be prompted to save or lose changes.
Node_1 | C1 CPU-3 XCON Rev A0-0 Ser 01103 | 12-31-99 14:33
1
HOST IP STATE
HOST IP ADDR
HOST NETMASK
DEFAULT IP PORT
stdby
0.0.0.0
0.0.0.0
n/a
DEFAULT IP SLOT n/a
DEFAULT IP UNIT n/a
RPT1 IP ADDR 0.0.0.0
RPT1 COMMUN STR
RPT2 IP ADDR 0.0.0.0
RPT2 COMMUN STR
RPT3 IP ADDR 0.0.0.0
RPT3 COMMUN STR
Ping | Netstat | rOute | Save | Undo | Refresh | Main